An effective metal firewall must be installed between the engine compartment and the cockpit. Late models use tubular frames and are built from the ground up as a purpose built race car. No chain or belt drives outside the engine that would power the rear wheels. Out of state customers are responsible to pay sales tax and any other government fees in their own state. The rim diameter must be 13 inches. Side visors on roll cage will be limited to eight 8 inches tall. Designed not to flex and provide optimal driver feel and comfort.
Voce race 4 cyl midget body throttle car have more
Welcome to our new look! Oiling system may be modified for reliability. Field will be inverted so that the highest point car under the handicapped system starts in the rear and lowest points position starts first. Sunset Speedway is proud to be part of the Pro Challenge racing family. Save weight by not running valve stems in your wheels even the front ones. The Director of Competition may reassign numbers at the conclusion of the season.
After two racing events that Driver will be asked to join the club as a regular member. The technical director may disallow a muffler that in their opinion is not within the spirit or intent of this rule. The crankshaft must be parallel to the bottom plane of the chassis. The Technical Director may have any panel or part removed which in their opinion is not within the spirit or intent of this rule. Arm restraints are mandatory. Roll Cage Nets — It is mandatory that all cars be fitted with roll cage nets on right side of the roll cage for all events, unless utilizing a full containment seat. Should two or more cars with the same number be entered in a competition, the Stewards will require that one or more cars be temporarily renumbered.
The left rear and both fronts may be a maximum of eight 8 inches in rim width. Side panels that include exit ducts may not extend more than 5 inches from the frame rails and may not extend past the front engine plate. Here is a great way to keep your fuel system clean. Brake discs are limited to being manufactured of steel, ferrous or aluminum alloy. Hillborn injectors, Vertex Magneto, stainless valves, JE pistons, and many other items.